Agilent Technologies 54657A Guide de l'utilisateur télécharger pdf (Page 56)

To automatically save test violations

The signals that fail the waveform monitoring test can be saved, then

viewed/measured at a later time. Provisions are provided to save the

violations in trace memory, or print a hardcopy of the data. When trace is

selected, the option of saving only the last violation, or saving all violations

are provided.

Setup for waveform monitoring as described previously.

2 Press

± .

3 Press the Mask Test softkey.

4 Press the Test Options softkey.

5 Press the Auto Save softkey to ON. This causes the Save To softkey to appear.

Determine how the test violations are being saved, and proceed as follows:

•

To print test violation data on an externally connected printer, toggle the

Save To softkey until Print is selected.

•

To save test violation data in trace memory, toggle the Save To softkey

until Trace is selected. This causes the Increment softkey to appear.

•

To save only the last test violation waveform in trace memory, toggle the

Increment softkey until Off is selected.

•

To save all test violation waveforms in trace memory, toggle the Increment

softkey until On is selected.

Press the Previous Menu softkey.

7 Press the Mask Test softkey until On is selected.

Operating the Measurement/Storage Module

To automatically save test violations

2–40

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 88 89

Pas de commentaire

Agilent Technologies 54657A Guide de l'utilisateur Page 56