Agilent Technologies E6392B Guide de l'utilisateur télécharger pdf (Page 38)

Chapter 2 37

Using Functions

Testing a Dual Band Mobile with MANUAL TEST (Synchronous mode)

2. Using Functions

• If the MS Call softkey is pressed, the following screen is displayed. Dial and

call from the mobile to proceed to the Talk/RF Test step. You can measure the

DC Current at Camp On stage while the MS Call step is blinking.

Step 14. Upon setting up the call setup, the Talk/RF Test screen is displayed as shown

below. IMSI, IMEI, Power Class, GSM Version, RX Quality, RX Level are shown.

For MS Call, Dialed No. is also included.

Step 15. While the Talk/RF Test step is blinking as above, you can select a test item by the

CURSOR CONTROL knob to execute its test. Place the cursor at “Peak TX

Power, Burst Timing, Power Ramp” and press the CURSOR CONTROL knob, for

example, to obtain the next screen.

Step 16. Press the Abort softkey to get other softkey menus.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 205 206

Pas de commentaire

Agilent Technologies E6392B Guide de l'utilisateur Page 38