Agilent Technologies E6392B Guide de l'utilisateur télécharger pdf (Page 97)

96 Chapter 3

Screen Reference

MANUAL TEST (Synchronous Mode)

Measuring: DC Current

NOTE DC current measurements can be executed only when the DC Power field is set to

On and dc power is supplied from the Test Set to the mobile phone.

Camp On DC Current is measured at the Camp On state for MS Call as shown in

Figure 3-30.

NOTE Camp On DC Current can be measured when the MS Call softkey is pressed and

before executing the call setup from the mobile.

Talk DC Current is measured at the Talk/RF Test state as shown in Figure 3-31.

Any data indicating a failure is highlighted.

Figure 3-30 Measuring: Camp On DC Current Screen

Softkey Menu

o Trigger Sing/Cont: Toggles the trigger mode between Sing

for single and

Cont

for continuous modes. In the continuous mode, this softkey is

highlighted blinking until the Abort softkey is pressed. In the single mode,

this softkey is highlighted for one measurement cycle.

o Abort: Stops continuous measurements and shows another softkey menu as

follows.

Figure 3-31 Aborted: Talk DC Current Screen

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 205 206

Pas de commentaire

Agilent Technologies E6392B Guide de l'utilisateur Page 97