Agilent Technologies E6392B Guide de l'utilisateur télécharger pdf (Page 45)

44 Chapter 2

Using Functions

Testing a Mobile with MANUAL TEST (GPRS mode)

The following procedure explains a test on a GSM mobile phone with the

MANUAL TEST GPRS mode, which is available with Option 040.

Step 1. Turn the Test Set on and wait for its selftest routine to finish.

Step 2. Refer to “Preparation for Each Test” on page 22 for the procedures required before

starting the test.

Step 3. Press the MANUAL TEST softkey in the initial screen to obtain the MANUAL

TEST: Stand-by screen shown below.

Step 4. If the Test Set is equipped with Option 040, make sure that GPRS

is selected

(underlined) in the Mode Sync/Async/GPRS softkey. (Note that this softkey is not

available for the Test Set without Option 040.)

Step 5. Check the differences of the test flow, three more parameters for slot

configurations, and less mobile related data fields from the MANUAL TEST

Synchronous mode. RX Quality and RX Level are not included in the Sensitivity

column in the test item table.

Step 6. Rotate the CURSOR CONTROL knob and see how the circular cursor changes its

position.

Step 7

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 205 206

Pas de commentaire

Agilent Technologies E6392B Guide de l'utilisateur Page 45