Agilent Technologies B2902 Manuel de service télécharger pdf (Page 52)

2- 12 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Command Summary

Setting Source/Measure Unit

[:SOUR[c]]:PULS:WIDT width

[:SOUR[c]]:PULS:WIDT? [DEFault|M

INimum|MAXimum]

Sets the pulse width for the specified

channel. The pulse width is the time from

starting the pulse peak output (or starting

the pulse level transition) to the end of the

pulse peak output.See Figures

2-2 and

2-4.

width=DEFault|MINimum|MAXimum|

5E-5 to 100000 seconds, in 1E-6

resolution

Minimum time for the pulse base output

is also 50 s. And the minimum pulse

period is 100 s.

5E-5

seconds

[:SOUR[c]]:SWE:DIR direction

[:SOUR[c]]:SWE:DIR?

Sets the sweep direction, UP or DOWN,

for the specified channel.

direction=DOWN|UP

[:SOUR[c]]:SWE:POIN points

[:SOUR[c]]:SWE:POIN? DEFault|MIN

imum|MAXimum

Sets the number of sweep steps for the

specified channel. This command setting

is effective for both current sweep and

voltage sweep.

points=DEFault|MINimum|MAXimum|

to 2500

The points value can be expressed by the

following formula, using the step value

set by the

[:SOUR[c]]:<CURR|VOLT>:STEP

command and the span value set by the

[:SOUR[c]]:<CURR|VOLT>:SPAN

command.

points = span/step + 1 (where step is not

points=1 sets step=0.

Command Summary Reset setting

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 325 326

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies B2902 Manuel de service Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies B2902