Agilent Technologies 81134A Manuel de service télécharger pdf (Page 9)

Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007 9

Introduction

For controlling the Agilent 81133A/81134A remotely, the

instrument provides three different interfaces:

•GPIB

Using the GPIB connector, the instrument can be controlled from

a PC or a UNIX Workstation.

•LAN

Using the LAN connector, the instrument can be connected to a

local area network and can be programmed from a PC.

•USB

USB is the replacement for GPIB when used on the bench. The

language is the same as with GPIB.

NOTE Your instrument’s firmware might not be set up for USB. USB

functionality is not available with the first release but will be

included in a later release of the firmware. Check the Agilent Web

page for update information.

Firmware Server and SCPI Commands All interfaces use the same SCPI- like language to communicate

with the instrument’s firmware server. The firmware server

implements a client server architecture, allowing to connect

multiple clients simultaneously.

The GUI also uses this language to communicate with the firmware

server. Therefore, everything that can be done via the user

interface can also be done via the programming interfaces.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 103 104

Pas de commentaire

Agilent Technologies 81134A Manuel de service Page 9