Agilent Technologies 81134A Manuel de service télécharger pdf (Page 99)

Troubleshooting

Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007 99

– If the trigger amplitude is increased, or

– if the offset is decreased.

• "low level of channel [1|2] is below minimum"

May happen:

– If the channel amplitude is increased, or

– if the offset is decreased.

• "high level of trigger exceeds maximum"

May happen:

– If the trigger amplitude is increased, or

– if the offset is increased.

• "high level of channel [1|2] exceeds maximum"

May happen:

– If the channel amplitude is increased, or

– if the offset is increased.

• "high level of trigger is lower than low level"

May happen:

– If the trigger amplitude is set to a negative value, or

– if high level and low level are set in parallel by list of

semicolon- separated SCPI commands.

• "high level of channel [1|2] is lower than low level"

May happen:

– If the channel amplitude is set to a negative value, or

– if high level and low levels are set in parallel by list of

semicolon- separated SCPI commands.

Instrument not Operable via LAN

If the instrument cannot be programmed via LAN, make sure that

you have installed the latest Agilent I/O library on your computer.

Visit the Agilent web site for the newest version.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104

Pas de commentaire

Agilent Technologies 81134A Manuel de service Page 99