Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service télécharger pdf (Page 235)

:CHANnel<n> Commands 10

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 235

:CHANnel<n>:PROBe:STYPe

(see page 860)

Command Syntax

:CHANnel<n>:PROBe:STYPe <signal type>

<signal type> ::= {DIFFerential | SINGle}

<n> ::= 1 to (# analog channels) in NR1 format

The :CHANnel<n>:PROBe:STYPe command sets the channel probe signal

type (STYPe) to differential or single- ended when using the 113xA Series

probes and determines how offset is applied.

When single- ended is selected, the :CHANnel<n>:OFFset command changes

the offset value of the probe amplifier. When differential is selected, the

:CHANnel<n>:OFFset command changes the offset value of the channel

Query Syntax

:CHANnel<n>:PROBe:STYPe?

The :CHANnel<n>:PROBe:STYPe? query returns the current probe signal

type setting for the selected channel.

Return Format

<signal type> ::= {DIFF | SING}

See Also • "Introduction to :CHANnel<n> Commands" on page 222

• ":CHANnel<n>:OFFSet" on page 230

This command is valid only for the 113xA Series probes.

Pas de commentaire

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service Page 235