Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service Page 446

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 970
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 445
446 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
23 :SAVE Commands
:SAVE:WAVeform[:STARt]
(see page 860)
Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
See Also "Introduction to :SAVE Commands" on page 434
":SAVE:WAVeform:FORMat" on page 447
":SAVE:WAVeform:LENGth" on page 448
":SAVE:FILename" on page 436
":RECall:SETup[:STARt]" on page 430
NOTE
Be sure to set the :SAVE:WAVeform:FORMat before saving waveform data. If the format is
NONE, the save waveform command will not succeed.
NOTE
If a file extension is provided as part of a specified <file_name>, and it does not match the
extension expected by the format specified in :SAVE:WAVeform:FORMat, the format will be
changed if the extension is a valid waveform file extension.
Vue de la page 445
1 2 ... 441 442 443 444 445 446 447 448 449 450 451 ... 969 970

Commentaires sur ces manuels

Pas de commentaire