Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service télécharger pdf (Page 422)

422 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

21 :POD Commands

:POD<n>:SIZE

(see page 860)

Command Syntax

:POD<n>:SIZE <value>

<n> ::= An integer, 1 or 2, is attached as a suffix to the command and

defines the group of channels that are affected by the command.

POD1 ::= D0-D7

POD2 ::= D8-D15

<value> ::= {SMALl | MEDium | LARGe}

The :POD<n>:SIZE command specifies the size of digital channels on the

display. Sizes are set for all pods. Therefore, if you set the size on pod 1

(for example), the same size is set on pod 2 as well.

Query Syntax

:POD<n>:SIZE?

The :POD<n>:SIZE? query returns the digital channels size setting.

Return Format

<size_value><NL>

<size_value> ::= {SMAL | MED | LARG}

See Also • "Introduction to :POD<n> Commands" on page 419

• ":DIGital<d>:SIZE" on page 252

• ":DIGital<d>:POSition" on page 251

This command is only valid for the MSO models.

Pas de commentaire

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service Page 422