Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service télécharger pdf (Page 310)

100

101

310 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

18 :MARKer Commands

Introduction to

:MARKer

Commands

The MARKer subsystem commands set and query the settings of X-axis

markers (X1 and X2 cursors) and the Y- axis markers (Y1 and Y2 cursors).

You can set and query the marker mode and source, the position of the X

and Y cursors, and query delta X and delta Y cursor values.

Reporting the Setup

Use :MARKer? to query setup information for the MARKer subsystem.

Return Format

The following is a sample response from the :MARKer? query. In this case,

the query was issued following a *RST and ":MARKer:MODE MANual"

command.

:MARK:X1Y1 CHAN1;X2Y2 CHAN1;MODE MAN

:MARKer:Y1Position

<position>[suffix]

(see page 317)

:MARKer:Y1Position?

(see page 317)

<position> ::= Y1 cursor position

value in NR3 format

[suffix] ::= {V | mV | dB}

<return_value> ::= Y1 cursor

position value in NR3 format

:MARKer:Y2Position

<position>[suffix]

(see page 318)

:MARKer:Y2Position?

(see page 318)

<position> ::= Y2 cursor position

value in NR3 format

[suffix] ::= {V | mV | dB}

<return_value> ::= Y2 cursor

position value in NR3 format

n/a :MARKer:YDELta? (see

page 319)

<return_value> ::= Y cursors

delta value in NR3 format

Table 78 :MARKer Commands Summary (continued)

Command Query Options and Query Returns

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 969 970

Commentaires sur ces manuels

Pas de commentaire

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service Page 310

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Agilent Technologies InfiniiVision 3000 DSO-X 3054A