Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service télécharger pdf (Page 550)

550 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

24 :SBUS<n> Commands

:SBUS<n>:UART:TRIGger:BASE

(see page 860)

Command Syntax

:SBUS<n>:UART:TRIGger:BASE <base>

<base> ::= {ASCii | HEX}

The :SBUS<n>:UART:TRIGger:BASE command sets the front panel

UART/RS232 trigger setup data selection option:

• ASCii — front panel data selection is from ASCII values.

• HEX — front panel data selection is from hexadecimal values.

The :SBUS<n>:UART:TRIGger:BASE setting does not affect the

:SBUS<n>:UART:TRIGger:DATA command which can always set data values

using ASCII or hexadecimal values.

Query Syntax

:SBUS<n>:UART:TRIGger:BASE?

The :SBUS<n>:UART:TRIGger:BASE? query returns the current UART base

Return Format

<base> ::= {ASC | HEX}

See Also • "Introduction to :TRIGger Commands" on page 641

• ":TRIGger:MODE" on page 648

• ":SBUS<n>:UART:TRIGger:DATA" on page 552

The :SBUS<n>:UART:TRIGger:BASE command is independent of the

:SBUS<n>:UART:BASE command which affects decode and Lister only.

Pas de commentaire

Agilent Technologies InfiniiVision 3000 DSO-X 3054A Manuel de service Page 550