Agilent Technologies EasyEXPERT Guide de l'utilisateur télécharger pdf (Page 185)

Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1 10-35

Error Message

Agilent FLEX Execution Error

205 DZ must be sent before RZ.

The RZ command is effective for the channels set to 0 V output by the

DZ command.

206 Do not specify the channel recovered by RZ.

Specify the channels that have not been recovered yet by the RZ

command after the DZ command. The RZ command cannot be

executed if the specified channels include a channel that has already

been recovered by the RZ command.

210 Ext trigger could not start measurement.

External trigger cannot start measurement because of busy condition.

211 TM1 must be sent to use GET.

Send the TM1 command to use the GPIB GET command (TRIGGER

statement in HP BASIC).

212 Compliance must be set correctly.

Compliance was not set or an incorrect compliance value was set in the

DV, DI, PV, PI, PWV, PWI, TDV, TDI, LSV, LSI, LSSV, LSSI, BSV,

BSI, BSSV, or BSSI command. Set the compliance value correctly.

213 Cannot perform self-test or calibration.

Self-test and calibration cannot be performed in the high voltage state.

Set the output voltage or the voltage compliance to the allowable

voltage for the interlock open condition or less to perform the self-test

or calibration.

214 Send MM before measurement trigger.

Before sending the measurement trigger, the MM command must be

sent to set the measurement mode.

217 Self-test is not defined for this module.

218 Cannot change output range.

The specified module failed the output range change. The output is set

to the initial condition 0 V and 100 A.

219 Channel output switch must be OFF.

The channel output switch must be OFF before executing the specified

command.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 227 228

Pas de commentaire

Agilent Technologies EasyEXPERT Guide de l'utilisateur Page 185