Agilent Technologies EasyEXPERT Guide de l'utilisateur télécharger pdf (Page 200)

10-50 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1

Error Message

Agilent FLEX Execution Error

2155 ALWG Pattern Data is not ready.

Pattern data must be set by using ALW before starting the output.

2156 Specified ALWG Pattern Data size is out of absolute limits.

Set the appropriate pattern data to ALW. Too large data was specified.

2157 Specified interval time of ALWG Pattern is out of absolute limits.

Set the appropriate pattern data to ALW. The incremental time value in

the pattern data must be 10 ns to 671.088630 ms in 10 ns resolution.

2158 Specified output voltage of ALWG Pattern Data is out of absolute

limits.

Set the appropriate pattern data to ALW. The output level value in the

pattern data must be 0 to

 40 V in 1 mV resolution.

2204 Load voltage is too small for DUT impedance measurement.

Failed to perform the terminal voltage measurement and the load

impedance calculation by the CORRSER? command. Set the SPGU

output voltage more than 1 V. Set high voltage for high impedance.

2206 Auto correction of load impedance failed.

Cannot perform the SPGU automatic level adjustment. Load

impedance exceeds the acceptable range. Change the SPGU output

voltage or the DUT.

3000 WGFMU module does not exist.

Check the channel number of the WGFMU module and set the correct

value.

3001 RSU is not connected.

Check the channel number of the WGFMU module connected to the

RSU and set the correct value.

3015 Measurement data corrupted.

Cannot get the measurement data. Correct measurement result is not

stored in the memory.

3050 Measurement data memory overflow error.

ALWG sequencer run time error. WGFMU module memory overflow

occurred. Data exceeds memory size could not be stored.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 227 228

Pas de commentaire

Agilent Technologies EasyEXPERT Guide de l'utilisateur Page 200