Agilent Technologies EasyEXPERT Guide de l'utilisateur télécharger pdf (Page 14)

6- 2 Agilent EasyEXPERT User’s Guide Vol. 2, Edition 1

Remote Control Interface

This chapter explains about the EasyEXPERT remote control interface which is a

command set used to control EasyEXPERT by using a program via LAN, and

consists of the following sections.

• “Introduction”

• “Notational Convention and Command Summary”

• “Common Commands”

• “BENCh Subsystem”

• “CALibration Subsystem”

• “RESult Subsystem”

• “STANDby Subsystem”

• “SYSTem Subsystem”

• “WORKspace Subsystem”

• “Error Messages”

NOTE The following conventions are used in this chapter.

• For Windows 7 64 bit version

<program folder>: <system drive>:\Program Files (x86)

• For Windows 7 32 bit version, Windows Vista, or Windows XP

<program folder>: <system drive>:\Program Files

<system drive>: Drive the EasyEXPERT has been installed

NOTE

Sample programs

Sample programs for using the EasyEXPERT remote control interface are stored in

the following folder. See the program code for your reference of programming.

<program folder>\Agilent\B1500\EasyEXPERT\Samples\Remote Control

NOTE

About socket services

Agilent instruments are standardized on using port 5025 for socket services. A data

socket on this port can be used to send and receive commands, queries, and query

responses. All commands must be terminated with a newline for the message to be

parsed. All query responses will also be terminated with a newline.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 227 228

Pas de commentaire

Agilent Technologies EasyEXPERT Guide de l'utilisateur Page 14