Agilent Technologies HP 8566B Spécifications télécharger pdf (Page 17)

General

Information

Introduction

This HP 8566B Tests and Adjustments Manual contains two main

sections: Performance Tests and Adjustments Procedures. This

chapter lists the required test equipment for both sections. The

performance tests provided should be performed for the following

reasons:

If the test equipment for the Operation Verification Program is not

available.

If the instrument does not pass all of the Operation Verification

tests.

For complete verification of specifications not covered by the

Operation Verification program.

The adjustment procedures should be performed for the following

reasons:

If the results of a performance test are not within the specifications.

After the replacement of a part or component that affects electrical

performance.

Warning

The adjustment procedures require access to the interior of the

instrument and therefore should only be performed by qualified

service personnel. There are voltages at many points in the

instrument which can, if contacted, cause personal injury. Be

extremely careful. Adjustments should be performed only by

trained service personnel.

Power is still applied to this instrument with the LINE switch in

STANDBY. There is no OFF position on the LINE switch. Before

removing or installing any assembly or printed circuit board,

remove the power cord from the rear of both instruments and

wait for the MAINS indicators (red

LEDs)

to go completely out.

Capacitors inside the instrument may still be charged even if the

instrument has been disconnected from its source of power. Use a

non-metallic tuning tool whenever possible.

General Information

1-l

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 404 405

Pas de commentaire

Agilent Technologies HP 8566B Spécifications Page 17